KitchenAid KGCU462VSS00 Installation Instructions Manual page 15

Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Replace Igniter - Small Surface Burners Only
1. Unplug igniter wire from electrode.
IMPORTANT: Do not let the igniter wire fall down under the
cooktop surface.
2. Using needle-nose pliers, remove the retaining clip and
spring from the igniter.
B
5. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into gas opening and press down onto the
gas orifice spud and remove by turning the gas orifice spud
counterclockwise and lifting out. Set gas orifice spud aside.
6. Replace with correct LP gas orifice spud. See the "LP Gas
Orifice Spud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
LP Gas Orifice Spud/Hood Chart
Burner Color Size Burner Style
Rating
3,000 BTU Blue 0.55 mm Small burners
12,500 BTU Brass 1.04 mm Medium burners
h
' t!o c o o o o s 0sj_
/
15,500 BTU Yellow 1.05 mm
Green 0.45 mm
Large burner - main
Large burner - simmer
7=
8.
14,500 BTU Black 1.18 mm Grill burner
Burner orifice spud
Grill orifice hood
A
A. Size stamp or color A. Size stamp
Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
For medium and large burners, replace the burner base using
both screws. Replace burner head and cap.
For small burners, replace igniter using the following
instructions.
3=
4.
5=
.... 7
A. Retaining clip
B. Spring
C. Natural gas igniter
Remove Natural gas igniter from burner base.
Place spacer ring onto the LP gas igniter and insert into the
burner base.
A
A. Spacer
Insert new spring from LP conversion kit onto the underside
of the igniter and lock into place with the new retaining clip.
B
A
i ....
A. Retaining clip
B. Spring
C. LP gas igniter
6. Place Natural gas igniter, spring, and clip in plastic parts bag
for future use and keep with package containing literature.
7. Plug in igniter wire.
8. Replace the burner base using both screws.
9. Replace burner head and cap.
15