Quick Start - Panasonic HDC-SX5 Operating Instructions Manual

Setup

Quick start

When quick start is ON the battery power is still
being consumed, even when the LCD monitor
and the viewfinder are closed.
This unit will resume recording/pause mode
about 1.7 seconds after the LCD monitor and the
viewfinder are reopened.
≥ When in quick start standby mode, about
70% of the power used in recording pause
mode is being consumed so the recording
time will be reduced.
≥ This is only activated in the following case.
sWhen the mode dial is set to
SD card is inserted.
1
Press the MENU button, then
select [SETUP] #
[QUICK START] # [ON] and
press the cursor button.
2
Close the LCD monitor and
retract the viewfinder while the
mode dial is set to
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
34
VQT1G66
3
The status indicator A lights red and the unit is
put into recording pause approx. 1.7 seconds
after it is turned on.
and an ª To cancel Quick start
Press the MENU button, then select [SETUP]
# [QUICK START] # [OFF] and press the
cursor button.
≥ The status indicator goes off, the lens cover
≥ The status indicator goes off and the power
MENU
≥ Quick start standby mode is cancelled, the
.
≥ When this unit is quick-started with the white
≥ When this unit is quick-started, the zoom
≥ If [POWER SAVE] (l 132) is set to
Open the LCD monitor or extend
the viewfinder.
closes and the power turns off if the mode dial
is set to OFF while the unit is in quick start
standby mode.
turns off if quick start standby mode continues
for approx. 5 minutes.
status indicator goes off and the power turns
off in the following cases.
jthe mode dial is switched
jthe battery is removed or the AC adaptor is
disconnected
balance on automatic, it may take some time
until the white balance is adjusted if the scene
being recorded has a light source different
from the scene last recorded. (When the colour
night view function is used, however, the white
balance of the scene last recorded is retained.)
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.