Connection and recognition
Connection and recognition
procedures
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognised by the computer.
≥ Connect after installing the software
applications.
≥ Remove the supplied CD-ROM if it is inserted
in the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥ If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥ If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
≥ Be sure to finalize all discs other than
DVD-RAM before using them with a
computer. Un-finalized discs cannot be
recognised by the computer.
1
Connect this unit to the AC
adaptor.
≥ If a battery is used, operation is not possible
when this unit is connected to a computer.
2
Insert a disc or card with
recorded images in the unit, then
turn on the unit.
3
Connect this unit and a
computer.
A USB cable (supplied)
The USB function selection screen will appear.
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥ Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB connection
cables.)
4
Select [PC CONNECT (DISC)] or
[PC CONNECT (CARD)] and then
press the cursor button.
This unit is automatically recognised by the
computer.
With a computer
119
VQT1G66