Product Dimensions - KitchenAid KDDC27TTS00 Installation Instructions Manual

Drawer Front #8 x 1/2"Pan-head Screw Locations
A
A--
A
A. Pre-drilled screw locations
....... A
Hardware Installation (optional)
Customer supplied handles (hardware) may be installed at this
time.
1. Measure and mark a line 3" (7.62 cm) down from the top of
the overlay panel as shown.
IMPORTANT: Install hardware a minimum of 3" (7.62 cm)
down from the top of the overlay panel. The space at the top
of the panel is needed in order to attach the overlay panel to
the drawer front.
A. 3" (7.62 cm) area
2. Center the custom hardware (left to right) onto the overlay
panel. When installing the custom hardware, be sure that the
mounting screws are flush with the back of the overlay panels.
3. Repeat the process for the other overlay panel.
Styles I and 2: Standard and Overlay
• Height dimensions are shown with the leveling legs extended
to the minimum height of 1/4"(6.35 mm) below the refrigerator
drawers.
• When leveling legs are fully extended to 1" (25 mm) below the
refrigerator drawers, add 3/4"(19.05 mm) to the height
dimensions.
The power cord is 60" (152.4 cm) long.
26.7"
(67.9 cm)
23.5" SS _34.0"
(59.6 cm)//_i, _!_,_,i_(86.3 cm)
Drawer Opening Dimensions
Dimensions vary based on model, as shown.
20,9"
(53,1
A. Style 1: Standard
B. Style 2: Overlay--Measurement does not include
_" (19.05 mm) overlay panel or optional hardware
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator drawer(s).
Failure to do so can result in death, explosion, or fire.
NOTES:
• For the refrigerator drawers to be flush with the front of the
base cabinets remove any baseboards or moldings from the
rear of the opening. See "Product Dimensions" and later in
this section "Opening Dimensions (both styles)."
• It is recommended that you do not install the refrigerator
drawers near an oven, radiator, or other heat source.
• Do not install in a location where the temperature will fall
below 55°F (13°C).
Opening Dimensions (both styles)
• Height dimensions are shown with the leveling legs extended
to the minimum height of 1/4"(6.35 mm) below the refrigerator
drawers.
NOTE: When leveling legs are fully extended to 1" (25 mm)
below the refrigerator drawers, add 3/4"(19.05 mm) to the
height dimensions. See "Product Dimensions."