Table of Contents
Advertisement
Available languages
Available languages
3=
4=
Remove the backing from the double-sided
tape. Install the
overlay panel to the drawer front. Be sure to align all edges of
the drawer front to the overlay panel. Be sure that the overlay
panel is level.
NOTE: The tape will secure the panel in place while drilling
the pilot holes.
A. Double-sided
tape
Using the pre-drilled holes in the drawer front as a guide, use
a scribe to mark the drilling locations on the overlay panel.
Drill six 1/8"diam. x 1/2"deep (3.18 mm x 12.7 mm) holes into
the overlay panel.
IMPORTANT:
Do not drill deeper than 1/2"(12.7 mm).
5. Drive six #8 x 1/2"pan-head screws through the drawer front
into the overlay panel.
6. Be sure that the overlay panels are flush with the bottom of
the drawer fronts.
Top Drawer
Bottom Drawer
7. Repeat the process for the other drawer front.
8. Using a Phillips screwdriver, reinstall the wiring plug cover
(upper drawer).
Reinstall the Gaskets
1. Starting at the corners, and working toward the opposite
corner, press the gasket back into the groove. Be sure to seat
the gasket on all four sides.
2. Repeat the process for the other drawer.
Install the Wire Baskets
Reinstall the wire baskets. See "Remove the Wire Baskets,"
earlier in this section.
IMPORTANT: To avoid damage to your cabinets or countertop,
be sure to secure the mounting brackets to the adjacent
cabinets.
1. Center the refrigerator drawers cabinet in the opening.
2. Pull out the upper drawer far enough to reach the mounting
brackets.
NOTE: Do not pull the drawer out more than midway.
3=
Using the upper mounting brackets as a guide, predrill two
W' (3.18 mm) holes through the mounting brackets (for each
side) into the adjacent cabinets. Be sure to drill at least two
holes per mounting bracket.
NOTE: Be sure the refrigerator drawers are level before
securing the upper mounting brackets.
4. Using four #8 x W' pan-head screws, attach the upper
mounting brackets to the adjacent cabinets.
A. Overlay panel
B. Drawer front
A. Mounting brackets
5. Repeat the process for the lower drawer.
10
Advertisement
Table of Contents
