Configuration (Standalone); Sound Active Mode; Automatic Mode - Chauvet Intimidator Spot LED 250 User Manual

Configuration
(Standalone)
Sound Active
Mode

Automatic Mode

Intimidator™ Spot LED 250 User Manual (Rev. 03)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound Active mode, do the following:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, SLAv
2. Press <UP> or <DOWN> to select NStS.
Press <ENTER>.
3.
4. Turn the music on and adjust the microphone sensitivity knob until the product
starts responding to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic Mode, follow the instructions below:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, SLAv
2. Press <UP> or <DOWN> to select NASl (for a slow light show) or NAFA (for a fast
light show).
Press <ENTER>.
3.
Page 15 of 26