Configuration (Standalone); Sound-Active Mode; Automatic Mode; Manual Pan/Tilt Operation - Chauvet Intimidator Beam LED 350 User Manual

Configuration
(Standalone)
Sound-Active
Mode

Automatic Mode

Manual Pan/Tilt
Operation
Pan/Tilt Angle
Range
Intimidator Beam LED 350 User Manual Rev. 4
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (either
Automatic, or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
nASL, nAFA, nStS, SLAv
2. Press <UP> or <DOWN> to select NStS.
3. Press <ENTER> and SrUn shows on the display.
4. Turn the music on.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic mode, do the following:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
nASL, nAFA, nStS, SLAv
2. Press <UP> or <DOWN> to select nASL (for a slow program) or nAFA (for a fast
program).
3. Press <ENTER> and SLoU displays while in slow program or FASt displays while
in fast program.
To select either normal panning or inverted panning, do the following:
1. Press <MODE/ESC> repeatedly until PAn or rPAn shows on the display.
2. Press <UP> or <DOWN> to select PAn (normal pan operation) or rPAn (inverse
pan operation).
3. Press <ENTER>.
To select either normal tilting or inverted tilting, do the following:
1. Press <MODE/ESC> repeatedly until tit shows on the display.
2. Press <UP> or <DOWN> to select tit (normal tilt operation) or rtit (inverse tilt
operation).
3. Press <ENTER>.
To select which pan angle to use:
1. Press <MODE/ESC> repeatedly until PA54, PA36, or PA18 shows on the display.
2. Press <UP> or <DOWN> to select PA54 (540°), PA36 (360°), or PA18 (180°).
3. Press <ENTER>.
To select which tilt angle to use:
1. Press <MODE/ESC> repeatedly until ti27, ti18, or ti 9 shows on the display.
2. Press <UP> or <DOWN> to select ti27 (270°), ti18 (180°), or ti 9 (90°).
3. Press <ENTER>.
Page 15 of 20