Kyocera KM-2560 Operation Manual page 79

OPERATION GUIDE
1
Press the
Status/Job
Cancel key.
2
Press [Device/
Communication],
and then
[Manual RX].
Reception will
start.
NOTE:
When using a telephone set that can send tone signals, use the
telephone to start the reception of originals with the remote switch
function. (Refer to Remote Switch Function on page 4-14.)
When you hear a voice from the receiving system
The telephone line has connected to the telephone of the sending system.
When the conversation is over, follow steps 1 to 2 above.
After the sending system has started transmission, the machine starts
receiving originals.
4
When reception starts (when the Receive indicator on the operation panel
starts blinking), return the handset to its original position.
FAX Operation (Advanced)
30/40/50 ppm model
Status
Scanner
Ready .
Printer
Ready .
Removable Memory
Not connected.
Format Remove
FAX Line 1
Ready .
Line Off Manual RX
FAX Log
Printing Jobs Sending Jobs Storing Jobs
Status
25/30 ppm model
Hard Disk
Memory Card
Not connected.
Format Printing list
FAX/i-FAX Check New FAX
Device/
Paper /Supplies
Communication
10/10/200 7 10:00
4-13
4