Setting The Tti Information - Kyocera KM-2560 Operation Manual

Preparation Before Use

Setting the TTI information

2-4
Register the name (local FAX name), fax number, and local FAX ID printed
in the transmit terminal identification (TTI) area.
By registering the TTI data, the receiver can easily find out where the FAX
came from.
Local FAX Name Registration
Register the local FAX name printed on in the transmit terminal
identification.
NOTE:
To change the entry, follow the same operation.
1
Press the System Menu key.
2
Press [FAX/i-FAX], [Next] of Transmission, [Next] of Basic, and then
[Change] of Local FAX Name Entry. The entry screen will be displayed.
3
Enter the Local FAX
Name to be
registered. Up to 16
characters can be
entered.
NOTE:
For details on character entry, refer to Character Entry Method on
page 2 of the Appendix.
4
Press [OK].
5
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Local FAX Information Entry
Register the local FAX information (local FAX number/ID) printed on in the
transmit terminal identification (TTI) area. The Local FAX ID is used for
transmission limit purposes. (Refer to Transmission Restriction on page 6-
16.)
NOTE:
If you install the Dual FAX option and then use 2 phone lines, you
can register Local Fax Numbers for each of the lines.
To change the registration contents, follow the same operation.
Local FAX Name Entry
Use the keyboard to enter.
1 2 3 4 5 6 7
q w e r t y u
a s d f g h
z x c v b n
Upper-case Lower-case No./Symbol
Status
Limit: 16 characters
Input: 0 characters
Backspace
8 9 0 - = `
i o p [ ]
j k l ; ·
m , . /
Space
Cancel OK
6/6/2006 10:00
OPERATION GUIDE