Xerox WorkCentre 5019 Network Addendum page 21

Advanced button
You can edit settings using the following buttons:
• Add UDP IPv4 Address button
Use to add a recipient address for UDP IPv4 trap notification.
– IP Address:
You can enter the IP address for entry.
– UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
– SNMP Version:
You can specify the SNMP version for entry as v1 or v2c. (Default: v1)
– Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code characters).
(Default: SNMP_trap)
– Trap to be Received:
You can set whether to send notifications for Print, Cold Start, and Authentication Failure
events.
• Add UDP IPv6 Address button
Use to add a recipient address for UDP IPv6 trap notification.
– IP Address:
You can enter the IP address for entry.
– UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
– SNMP Version:
You can specify the SNMP version for entry as v1 or v2c. (Default: v1)
– Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code characters).
(Default: SNMP_trap)
– Trap to be Received:
You can set whether to send notifications for Print, Cold Start, and Authentication Failure
events.
• Delete button
Use to delete the traps specified for the trap notification recipient IP address.
• Edit button
Use to display the notification information for the trap you are using. You can specify the events
for which to send notification.
Apply button
Use to apply changes.
Note Reboot the machine to enable the new settings.
® ®
Xerox WorkCentre 5019/5021
Network Addendum
21