KTM 2008 1190 RC8 USA Owner's Manual page 193

MAINTENANCE WORK ON CHASSIS AND ENGINE
Setting a lower seat position:
–
Remove screw
–
Push the rear end down until the drill holes of the frame are level with the upper
rear drill holes of the rear.
–
Mount the screw and washer on the left and right sides of the vehicle, but do not
tighten.
700327-12
–
Remove screw
–
Push the rear end up until the drill holes of the frame are level with the upper front
drill holes of the rear.
700327-14
–
Mount the screw and washer on the left and right sides of the vehicle, and tighten.
Guideline
Screw, subframe
700329-01
with washer on the left and right sides of the vehicle.

with washer on the left and right sides of the vehicle.

M8 25 Nm Loctite ® 243™
(18.4 lbf ft)
191