KTM 2008 1190 RC8 USA Owner's Manual page 129

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
The position of the shift lever can be greatly varied, depending on the length of the shift
rod and the drill holes selected. As seen from the footrest, there is either a high position
of the shift lever
Info
If you turn the reverse shift shaft 2 teeth on the serration of the shift shaft, you
can adjust the footrest system optimally for the upper footrest position.
–
After adjusting the shift lever, conduct a function test. There must be a minimum dis-
tance between the moving parts of the shift lever and other parts of the vehicle.
Guideline
Minimum distance
700344-01
or a low position of the shift lever

5 mm (0.2 in)
.

127