Attaching An Alternative Anti-Tip Device - Thermador T24IF70NSP/47 Installation Instructions Manual

Fasteningwith wood screws
7.
4x15
: iiiii! _
Fastening with dowels and screws
Always wear safety glasses and other necessary pro-
tective devices or apparel when installing or working
with anchors.
Risk of injury!
Not recommended for use in light-weight masonry material
such as block or brick.
Not recommended for use in new concrete which has not
had time to cure.
Do not use core drills to drill holes for this anchor.
5x60
6x31
_N6
Attaching an alternative anti-tip
device
If the anti-tip ang[ess cannot be attached securely,
an alternative anti-tip device can be attached.
However, ensure that there is no play between the
appliance and the anti-tip device.
If possible, always screw the wooden beam to existing
studs on the rear panel of the cavity.
• Saw the wooden beam (cross section min. 3" x 4')
to the required length.
Length is equal to the width of the installation cavity!
If the installation cavity is deeper than the
appliance, select a beam which has a larger cross
section or attach 2 beams.
The beam must cover the appliance by
at least 2" (50.8 mm).
(50,8)
(21
÷ 1/32
÷lmm
Mark the installation height (lower edge of the beam) on
the rear panel of the cavity.
Select screws according to the thickness of the wooden
beam: length = rain. 2.5 x beam thickness, diameter
#12 or #14.
23