15, Checking That The Finger Guard Moves Easily; 16, Connecting The Water To The Appliance - Thermador T24IF70NSP/47 Installation Instructions Manual

15. Checking that the finger guard
moves easily
It is now essential to check that the finger guard moves
easily. At a later time any required corrections will be more
difficult.
Note:
The supplied finger guard can be used for both sides of the
door hinge.
Because of different installation possibilities, the finger guard
has to be shortened to the required length.
• Shorten the finger guard at the upper side above the
covering strip by 55 mm (1.).
E
E
16.
Connecting the water to the
appliance
When bending the water pipe, do not kink it, otherwise
there is a risk of leaks and water damage.
When connecting the water pipe to the solenoid valve
of the appliance, follow the instructions supplied by the
manufacturer of the ice maker installation kit enclosed
with the installation manual.
• Push the offcut on the hinge side into the gap between
the appliance and cavity wall.
The part has to be easy pushing and pulling (2.)!
Ensure smooth running at all positions of the door (3.).
• Remove the cap from the appliance connection (1.).
• Bend the water pipe according to the location of the
connection on the appliance (2.).
• Push the union nut and seal onto the water pipe.
• Push the end of the water pipe into the appliance
connection and screw on the union nut (3.).
Tighten hand-tight.
• Using the open-ended wrench, tighten the union nut.
Do not overturn!
• Open the shut-off valve and main water tap.
• Check the connection on the shut-off valve and on the
appliance for leaks.
28