Table of Contents
Advertisement
Installing
the Mast or a Pole (continued)
Note
• The toggler must lie completelyflat
against the inside of the cinder block
to be effective.
B)
Pull the toggler toward
you to apply tension while sliding
the plastic cap until it is snug against the wall.
Block Wall
Ring _'_
Plastic Cap
C)
Break the ring along the center perforation
and push the
two halves away from each other. Push them toward the
wall until they break at the plastic cap.
Break
8
Use a 1/4" - 20 x 3" machine screw to attach the mast to the cinder
block. Do not tighten the screw too securely to allow for
adjustment.
9
Check to make sure the mast is still level.
10
Mark the remaining three outer holes, and repeat steps 6 through 9.
11
Tighten all four bolts.
Proceed to Installing the Antenna on page 31.
30
Chapter 3: Installing the Mast or a Pole
Advertisement
Table of Contents
