Table of Contents
Advertisement
4
Use a level to determine
whether
the mast can be vertically
aligned before you drill any holes.
Level
Jstment
Nuts
(ea. side)
'
Mast
-_
Level the Mast
_
at Right Angles
Note
• Fill mistakes with mortar or silicon
sealant.
Side View
Top View
A) Loosen the pivot bolt and adjustment
nuts that connect the
bottom of the mast to the base plate and align the mast in a
vertical position.
B) Place the level along the top part of the mast and take two
readings
90 ° apart from each other.
C) Tighten the pivot bolt and adjustment nuts.
5
Mark the upper left hole of the base plate with the pencil.
6
Remove the mast and drill a l/f, hole.
7
Install a toggler.
A)
Fold the metal channel fiat against the toggler and insert it
into the hole until the channel opens.
Fold in
!" Drill Thru
Toggler
Metal
Channel
(continued)
Chapter 3: Installing the Mast or a Pole
29
Advertisement
Table of Contents
