Table of Contents
Advertisement
Installing
the Mast or a Pole (continued)
Tools and materials needed for this installation:
Drill bits (1/8", 3/ld')
*Lag screws (2) 1/4"x 3", (4) s/_d' x 2"
Level
Pencil/chalk
Power drill
*Silicon sealant
Tape measure
*Washers (4) s/16"
Wrench (3/8")
*Included in the Installation Kit.
>Warning
• Do not install the antenna near power lines.
>.Caution
• DO not install the antenna where it could be bumped or jarred by people,
furniture, doors or pets.
• Do not attempt any installation in rainy or windy conditions.
Installation
instructions:
1
Choose a secure location to install the base plate:
UI Side of your house -- find a wall stud on which you can
secure the base plate. Wall studs can be located by a vertical
line of nails where siding is attached to the house, or with a
stud finder.
Outside Holes
(4) 5/16"x 2"
Lag Screws
Center Holes
(2) 1/4"x3"
LagScrews
Wooden Shim (for
Siding only)
20
Chapter 3: Installing the Mast or a Pole
Advertisement
Table of Contents
