Heat Sink - HP Compaq 8710p Maintenance And Service Manual

Heat sink

NOTE: Replacement thermal material is included with all heat sink spare part kits.
Description
For use only with computer models equipped with processors with 3- or 6-MB L2 cache
For use only with computer models equipped with processors with 2- or 4-MB L2 cache
Before removing the processor heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Keyboard (see
b. Switch cover (see
c. Fan/heat sink assembly (see
Remove the processor heat sink:
1. Loosen the four Phillips PM2.5×7.0 screws (1) that secure the processor heat sink to the base
enclosure.
2. Lift the right side of the processor heat sink (2) until it disengages from the processor.
3. Release the processor heat sink (3) by sliding it to the right until it clears the base enclosure.
4. Remove the processor heat sink.
76 Chapter 4 Removal and replacement procedures
Battery on page 46).
Keyboard on page 62)
Switch cover on page
Fan/heat sink assembly on page
69)
72)
Spare part number
468593-001
450593-001