System Board - HP Compaq 8710p Maintenance And Service Manual

System board

NOTE: Replacement thermal material is included with all system board spare part kits.
Description
For use only with computer models equipped with processors with 3- or 6-MB L2 cache
For use only with computer models equipped with processors with 2- or 4-MB L2 cache
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
b. Hard drive (see
c. Bluetooth module (see
d. Optical drive (see
e. Keyboard (see
f. TouchPad (see
g. Switch cover (see
h. Fan/heat sink assembly (see
i. Graphics card (see
j. Processor heat sink (see
k. Display assembly (see
l. Top cover (see
m. Speaker assembly (see
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules (see
on page
●
WLAN module (see
●
RTC battery (see
● Modem module (see
Battery on page
Hard drive on page
Bluetooth module on page
Optical drive on page
Keyboard on page
TouchPad on page
Switch cover on page
Graphics card on page
Heat sink on page
Display assembly on page
Top cover on page
Speaker assembly on page
Primary memory module on page 54
65)
WLAN module on page
RTC battery on page
Modem module on page
46)
50)
53)
60)
62)
66)
69)
Fan/heat sink assembly on page
74)
76)
79)
85)
56)
59)
68)
Component replacement procedures
Spare part number
468591-001
450482-001
72)
87)
and Expansion memory module
89