Spektrum AR7100 Series User Manual page 25

Problem
The system will not connect
Receiver quits responding during
operation
Receiver loses its bind
Receiver blinking at landing
Spektrum AR7100
Possible Cause
Your transmitter and receiver are too close
together. They should be 8 to 12 feet apart
You are around metal objects
Model selected is not the model bound to
Your transmitter was accidentally put into
bind mode and is not bound to your receiver
anymore
Inadequate battery voltage
Loose or damaged wires or connectors
between battery and receiver
Transmitter stand or tray could be depressing
the bind button
Bind button pressed before transmitter turned
on
System turned on and connected then receiver
turned off without turning off transmitter
Solution
Move transmitter 8 to 12 feet from receiver
Move to an area with less metal
Check model selected and ensure you are bound to that model
Rebind your transmitter and receiver
Charge batteries. Spektrum receivers require at least 3.5V to operate.
An inadequate power supply can allow voltage to momentarily drop
below 3.5V and cause the receiver to brown out and reconnect
Check the wires and connection between battery and receiver. Repair
or replace wires and/or connectors
If stand is depressing bind button, remove from stand and rebind
Rebind your system following binding instructions
Turn off transmitter when receiver is turned off
EN
25