Burner Assembly - Carrier KGANP5201VSP Installation Instructions Manual

1337932-701]
CONTAINS: QTY
PART # DESCRIPTION
328456-402 BIT, DRILL 1
FAJ5812B SCREW 7
REQUIRED FOR CONVERSION OF
CONDENSING GAS FURNACE TO
PROPANE GAS.
Fig. 6 - Gas Conversion Kit
A11294
2-in.
(50 mm)
3/16- in.
(4.6 mm)
_ /32 -in., +1/32 -3/64-in.
(2.5 mm, +0.8-1.5)
A12392
Fig. 9 - Igniter Position - Side View
CONVERT GAS VALVE
1.9"
(48.76 mm)
1.8"
(46.96 ram)
Drill out with
J 7/64" drill bit
ii /
\\\\
A11460
Fig. 7 - Mixer Screw Location
REINSTALL BURNER ASSEMBLY
To reinstall burner assembly:
1. Attach flame sensor to burner assembly.
2. Insert one-piece burner in slot on sides of burner box and
slide burner back in place.
3. Reattach HSI wires to HSI.
4. Verify igniter to burner alignment. See Fig. 8 and 9.
, ,Oo
II I
-2-1/2-in.
(64.4)
Fig. 8 - Igniter Position - Top View
A11405
FIRE, EXPLOSION, ELECTRICAL SHOCK
HAZARD
Failure to follow this warning could result in personal
iniury, death or property damage.
Gas supply MUST be shut off before disconnecting
electrical power and proceeding with conversion.
ELECTRICAL SHOCK, FIRE OR EXPLOSION
HAZARD
Failure to follow this warning could result in personal
iniury, death or property damage.
Before installing, modifying, or servicing system, main
electrical disconnect switch must be in the OFF position and
install a lockout tag. There may be more than one
disconnect switch. Lock out and tag switch with a suitable
warning label. Verify proper operation after servicing.
Refer to Fig. 10 and 11.
Fig. 10 - Propane Jumper
A11373