Table of Contents
Advertisement
Ending a Call
Ending a Call
If the subscriber you are speaking to ends the call, the busy signal for your telephone is switched off after a
few seconds and you can be reached again. This also applies when you are connected via headset. The time
interval until the busy signal is switched off is configured by the system administrator. All other connections
are ended after 20 seconds when the receiver is not replaced.
Accepting Calls
When there is an incoming call, an event window with information on the call appears on the display and the
display illumination is switched on.
... or
optional:
... or
Reject
/
... or
Calls are ended by pressing the end key briefly.
Press the call key.
When Auto answer" is activated (see page 126) – remove the mobile unit from the
charging station
The ring tone and/or vibration alarm are switched off, you can, however, still accept
the call.
Press softkey (alternatively: end key) The call is rejected. The caller hears the busy
signal.
Press softkey briefly and select one of the menu entries offered, please refer to
Incoming Call Menu starting on page 69
Telephoning
67
Advertisement
Table of Contents
