Table of Contents
Advertisement
Power Supply / Power Supply Unit
You can also remove the guides by pressing a suitable screwdriver in the longish
holes on the bottom of the charger.
Connect the power supply unit with the charger and place the connecting cable
through the cable guide. If necessary, change the connector of the power supply (see Power Supply / Power
Supply Unit on page 17).
Where to Set It Up
Your telephone is made for normal usage conditions. Today's furniture is coated with a sheer myriad of
lacquers and plastics and treated with various lacquer care products. It is possible that some of these
materials contain components which can attack and deteriorate the plastic feet of the charging station. The
device feet altered by these foreign substances may leave undesirable marks on furniture surfaces.
For understandable reasons, the manufacturer cannot assume liability for these types of damage. This is why
you should use an anti-slip mat under your charging station – particularly with furniture that is new or has
been freshened up with lacquer care products.
N
Power Supply / Power Supply Unit
The power supply unit is suitable for 100V to 240V alternating current (50-60 Hz). It comes with 4 inter-
changeable adapters so it can be used practically anywhere worldwide. As needed, put the connector on the
power supply used in your country. Mounting varies slightly as there are two variants of the power supply
connector:
Variant 1: Position the switch on the power supply at OPEN and slide the connector in place upwards and off.
Stick the desired new connector into the power supply and lock it by positioning the switch at LOCK.
Variant 2: Remove the connector if one is there by pressing OPEN. Then place the desired new connector
into the power supply slightly diagonally with the TOP designation showing upwards. Press it down until it
clicks into place.
When you wish to disconnect the charger from the power supply, pull the power supply unit plug out of the
mains socket. If there is a power outage, all memory data (programme and user data) are saved on the mobile
unit without alteration.
Note: Please make sure you do not set up the charging station in the space where
doors or windows open: Damage Risk!
Installation
17
Advertisement
Table of Contents
