Slp Settings; To Specify Slp Settings - Oce cm 2520 User Manual
Network scanner operations
Hide thumbs
Also See for cm 2520:
- Safety information & getting started (27 pages) ,
- Programming date & time (3 pages)
Table of Contents
Advertisement
3
3.27
SLP Settings
The use of SLP can be enabled or disabled. If set to "Enable", devices can
be searched using TWAIN. If set to "Disable", device cannot be searched.
To specify SLP settings
1
In the Administrator Setting screen, touch [5 Network Setting]. (Refer to
page 3-8 for more details.)
2
In the Network Setting screen, touch [9 Detail Setting].
3
In the Detail Setting screen, touch [6 SLP Setting].
The SLP Setting screen appears.
4
Touch [Enable] or [Disable].
5
Touch [OK].
The use of SLP is enabled or disabled.
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area. Otherwise, cancel the Utility mode by touching [Close] in each
screen until the screen for the Copy, Fax, Scan or Box mode appears.
3-116
Specifying Settings From the Control Panel
cm2520
Advertisement
Table of Contents
