Oce cm 2520 User Manual page 194

Specifying Settings From the Control Panel
13
Specify the desired setting.
14
Touch [Fwd.→].
Setting Up LDAP screen 6/6 appears.
15
Specify the desired settings.
16
Touch [OK].
The LDAP server registration and authentication are set.
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area or press the [Utility/Counter] key. Otherwise, cancel the Utility mode
by touching [Close] in each screen until the screen for the Copy, Fax,
Scan or Box mode appears.
Reminder
If the LDAP server settings are not specified correctly, network failure
may occur. The server administrator should specify LDAP settings.
cm2520
3
3-83