Changing The Battery Pack; Wiring Of The Connector; The Battery Pack - Look Solutions Power-Tiny Operating Manual

5. Operating the Power-Tiny
5.5 Battery Status Display/Sleep mode
The yellow light-emitting diode (LED) [11] on the Power-Tiny indicates how
strong/efficient the battery still is and/or when it must be recharged.
1) LED flashes slowly: Battery capacity of 15% – 100 %, the battery is fully
operational.
2) LED flashes fast: Battery capacity below 15%, the battery should be changed
and/or charged.
3) LED lights up permanently: the battery is flat or the vaporizer is damaged
4) LED does not light although the battery is connected:
Approx. 40 Seconds after the last fogging the Power-Tiny changes into the
sleep mode automatically. It then only needs a current of 1.5 mA. To awake
the machine press the startbutton [1].

5.6 Changing the battery pack

The battery pack [4] can be changed on site, for example if one battery pack is
empty and there is not enough time to recharge it.
To change the battery pack [4] unplug the battery connector [6] from the
machine. Unscrew the thumb screws [7] and disconnect machine and battery pack.
Put the Power-Tiny on a new battery pack and fix it with the screws. Connect the
battery pack to the machine.

5.7 Wiring of the connector

3pin XLR (analog):
Pin 1 = Ground, Pin 2 = 0-10 V + DC in, Pin 3 = 12 V + DC out, max. 50 mA
The supplied battery pack is supplied with a maintenance-free 12V lead-gel
accumulator which is calibrated in the best possible way with the connected loads
of the Power-Tiny. It can be used in every position.
The connection to the Power-Tiny is done with a Speakon NL4FX high current
plug, the connecting to the charger is done with a small connector.

6. The battery pack

9