Introduction - Landice Cardio Owner's Manual

Congratulations! You've made a very smart investment! Your Cardio Treadmill is a high-quality fitness tool that will give you
years and years of fitness benefits. One of the great things about the Cardio Treadmill is its diversity of applications. It's ter-
rific for just starting out on a walking program or easy jog. In the case of a veteran runner, it's the exact prescription needed
for precision interval training to lower your 10K time.
Regardless of the application, unpleasant weather is not an obstacle. Cold, windy, wet days will never discourage you again,
nor will the heat and humidity of the summer months. If you're the type of person that likes to do two things at once, now
you can watch your favorite program on TV or keep an eye on your kids and take care of your health at the same time.
Your treadmill was a smart purchase, but you already knew that, so let's move on and get started.
Following are some things you should do before you start to exercise on your treadmill:
INSTRUCTION MANUAL
Be sure to familiarize yourself with this manual. Look it over carefully. Be sure you understand the control panel operation
before using the treadmill.
WARRANTY INFORMATION
Fill out your warranty registration card and mail it in today. Landice backs your treadmill with a strong warranty.
For the factory to respond to any problems you may have, we need your warranty information on file. Do it today.
Landice will send you a complimentary Landice T-shirt upon receipt of your warranty registration card.
SELECTING A LOCATION
Install your treadmill in a climate controlled room.
Allow a minimum clearance of 18 inches on each side of the treadmill.
Allow a minimum clearance of 4 feet at the rear of the treadmill.
Failure to leave ample clearance at the rear of the treadmill could result in the user becoming trapped between the treadmill
and the wall should the user accidentally trip and fall while exercising. Be sure the line cord has plenty of slack and does not
get pinched underneath the treadmill when the treadmill elevates up and down. Make sure the treadmill is plugged into a
dedicated line.
STEP 1:
Unbolt treadmill from pallet
• On L7 treadmills it is necessary
to remove the bolts which hold
the treadmill to the pallet.
• Start by removing the top bolts.
• Lay the treadmill on the ground,
and then remove the bottom
bolts by placing the treadmill on
your toolbox.
• With the bolts removed, the
treadmill will be free to move
around in the box.
1

Introduction

BEFORE YOU BEGIN
Assembly Instructions
STEP 2:
Cut the box off the pallet
• Remove the metal strapping
around the box.
• Using a razor blade knife, cut the
box just above the bottom row
of brass staples along all sides
of the box.
• DO NOT cut through the
center of the box, as you could
damage the treadmill.
• Remove the box and discard.
STEP 3:
Unstrap the treadmill
• The treadmill components
are held together with plastic
strapping.
• Carefully cut and remove the
strapping. Remove the treadmill
upright and accessory boxes
from the treadmill. Lift the
treadmill off the pallet.
• Carefully remove the upright
side cover from the upright
assembly.