Grill Lighting Instructions; Manual Lighting - Team Grill PMV06091 User Manual

Grill Lighting Instructions

1. Ensure the appliance is assembled in accordance with the instructions included in this User Guide.
2. Ensure that the LP gas cylinder or NG supply is properly connected.
3. Inspect the hose before each use. If evidence of abrasion, wear, cuts or any other damage exists, replace the
hose before using the appliance. Use only replacement parts from
Team Grill.
4. Ensure that there are no gas leaks. See "Checking for Leaks" section
of this manual.
5. Ensure that the venturi tubes/burners are properly aligned on the
burner control valve orifices. (See Fig. 2)
6. Ensure that the main igniter wires are properly connected. As
applicable, ensure that the side burner and rotisserie burner igniter
wires are properly connected.
7. Read and understand all instructions as they pertain to this appliance
before lighting.
8. Open the lid and make sure the burner control knobs are in the "OFF" position.
9. Slowly open LP gas cylinder service valve or NG supply valve.
10. TO LIGHT THE MAIN BURNERS, SIDE BURNER AND INFRARED SEARING BURNER: Push in the desired burner
control knob. While holding the knob in, turn it slowly to the "
burner, release the knob. To adjust the burner after lighting, turn the knob to the desired setting. If ignition
does not occur within 5 seconds or burner goes out, turn burner control knob(s) back to the "OFF" position,
wait 5 minutes and repeat the lighting procedure.
11. If ignition does not occur within 5 sec., turn burner control knob(s) to "OFF", wait 5 minutes and repeat
lighting procedure. If any burner will not light, refer to the "Troubleshooting" section of this User Guide. If
the problem cannot be resolved, contact our customer service department at 888-978-6475 or a licensed
gas technician before using the appliance.
12. Do not operate the main and rotisserie burners at the same time.
13. When on "HIGH" position, the main burners should provide a 1" (2.5cm) flame. (See Fig. 2-1).
14. TO LIGHT THE ROTISSERIE BURNER (if applicable): Push in the burner control knob. While holding the knob
in, turn it slowly to the "
the burner after lighting, turn the knob to the desired setting. If ignition does not occur within 5 seconds or
burner goes out, turn burner control knob(s) back to the "OFF" position, wait 5 minutes and repeat the
lighting procedure.

Manual Lighting

If the igniter does not light the burner(s), use a lit match (secured onto the match stick provided inside right
cabinet door) to light the burners manually. Access the burners through the cooking grids and heat plates.
Position the lit match near the side of the burner while pushing and turning closest burner control knob to the
" " position. (See Fig. 2-2) The burner should ignite within 5 seconds. Once the burner has ignited, push
/ HIGH
Team Grill Patio Series User Guide
" position. After the igniter lights the burner, release the knob. To adjust
/ HIGH
" position. After the igniter lights the
/ HIGH
Page 36