Hose & Regulator Assembly (For Lp Models Only) - Team Grill PMV06091 User Manual

17. If the outdoor cooking gas appliance is not in use, the gas must be turned off at the supply cylinder.
Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is disconnected
and removed from the outdoor cooking gas appliance.
18. Cylinders must be stored outdoors out of the reach of children and must not be stored in a building,
garage or any other enclosed area.
19. Always use the pressure regulator and hose assembly provided with the appliance to connect to a LP gas
cylinder. Never connect to an unregulated LP gas supply.
20. When connecting the LP gas cylinder to the appliance, always test for gas leaks. See the "Checking for
Leaks" section of this manual.
21. If you smell gas, do not use the appliance until the source of the leak has been detected and repaired.
See the "Checking for Leaks" section of this manual.
22. Always shut off the LP gas cylinder service valve as well as the burner control valves when the appliance
is not in use.
23. Be sure the LP gas cylinder service valve and burner control valve(s) are "OFF" when the grill is not in
use.
24. Set a full LP gas cylinder into the well located on the bottom of
the appliance and secure in place.
25. Center the probe of the appliance side connection in the
cylinder service valve outlet and hold in place. With your other
hand, turn the plastic nut clockwise until fully engaged on the
cylinder service valve ACME thread. (See Fig.4) DO NOT USE
TOOLS. HAND TIGHTEN ONLY.
26. Perform the leak test (see the "Checking for Leaks" section of
this manual) on all connections.
27. When lighting the grill, follow the lighting instructions as
stated in this manual. Always open the LP gas cylinder service
valve before opening the burner control valve(s) to avoid
activating the flow limiting device. See "Hose and Regulator Assembly" section of this manual for more
details of the flow limiting device.
28. To disconnect the LP cylinder, shut off the gas supply, then unscrew the regulator from the cylinder, and
unscrew the bolt which is in the cylinder holder.
Hose & Regulator Assembly (For LP Models Only)
All models come equipped with a standard Elastomeric Composite Hose and
Couplings for Conducting Propane and Natural Gas, CAN/CGA-8.1 or with the
Current Standard, Thermoplastic Hose and Hose Couplings for Conducting
Propane and Natural Gas CAN1-8.3, listed hose assembly if the grill is to be
connected to a cylinder equipped with other than a No. 600 connection.
1. The CGA No 791 connection incorporates a magnetic flow limiting
device that acts to limit the flow of gas if a leak is detected between
the regulator and the burner valve(s).
Team Grill Patio Series User Guide Page 32