Grill Lighting Instructions - Team Grill pgd User Manual

Patio series game-day
Table of Contents

Advertisement

If the
1.
2.
grill contains
electrical
components:
To protect against
electric
shock, do not immerse
cord or plugs in water or other liquid.
Unplug
components
from the outlet when
not in use and before
cleaning.
Allow the grill to cool
before
putting on or taking off parts.
3.
Do not operate
the grill with a damaged
cord, plug, or after the grill malfunctions
or has been
damaged
in any manner. Contact
your local grill service
provider
or Team Grill for repairs.
4.
Do not let the cord hang over the edge of a table or touch hot surfaces.
5.
Do not use the grill for purposes
other than intended.
6.
When
connecting,
always
connect
the plug to the grill first, then
plug the appliance
into the
outlet.
7.
Use only a Ground
Fault Interrupter
(GFI) protected
circuit with this grill.
8.
Never remove the grounding
plug or use with a two-prong
adapter.
9.
Use
only
extension
cords
with
a three-prong
grounding
plug,
rated
for the
power
of the
equipment,
and approved
for outdoor
use with a W-A marking.
IMPORTANT!
BEFORE
LIGHTING
THE GRILL
Finally,
inspect
the gas supply
hose
before
turning
on the gas. If there
is evidence
of cuts, wear, or
abrasion,
the hose must be replaced
before
use. ALWAYS
INSPECT
THE HOSE
BEFORE
EACH USE
OF THIS GRILL.
Grill Lighting
Instructions
CAUTION i
1. Do not store a spare LP cylinder
under or near a barbecue
grill, or other
heat sources.
Never fill an LP cylinder
beyond
80% full: a fire causing
death
or serious injury may occur.
2. The gas pressure
regulator
provided
with this outdoor
cooking
gas
appliance
must be used.
3. Accessible
surfaces
may become
hot.
4. Turn off LP supply at cylinder
when appliance
is not in use.
Grill Lighting
instructions:
1. Read all lighting instructions before lighting.
2. iMPORTANT:
Open the lid before lighting.
3. To ignite, push and turn the ignition burner control knob to _/HI.
4. Push the ignition button in to light the burner.
5. To light the left and right burners,
push and turn the desired
burner control knob to HI.
6. If ignition does not occur within 5 seconds,
turn all burner controls
off, wait 5 minutes
and repeat the
lighting procedure.
7. If any of the burners
do not light, refer to the match lighting procedure
that follows.
Team Grill Patio Series GAME-DAY User Guide
Page 22

Advertisement

Table of Contents
loading

This manual is also suitable for:

120901/pgd11091Pgd120901Pgd11091

Table of Contents