To Extinguish Your Grill; Cleaning & Maintenance - Team Grill PMV06091 User Manual

and turn other burner control knobs to the "
other burners.
IMPORTANT: If a burner does not light within 5 sec., turn off all control knobs
and the gas supply, wait 5 minutes and repeat.
NOTE: Always use the match stick provided when lighting burners with a
match. After lighting, observe the burner flame, ensuring that all burners are
lit and the flame height matches the illustration above. (See Fig. 2-1)
NOTES:
1. To light side or rotisserie burners with a match, position the flame close to the burner and repeat steps
above. Do not operate the main and rotisserie burners at the same time.
2. When using the rotisserie burner, remove the warming rack.
3. Always check the burner to confirm that ignition has occurred.

To Extinguish Your Grill:

1. Turn the LP gas tank valve or NG supply line to the "OFF" position.
2. Turn all burner control valves to the "OFF" position. This sequence prevents residual gas from being left in
the system under pressure.
3. Close the lid of the grill.
4. Disconnect the LP gas tank when this grill is not in use:
a. Turn all burner control knobs to the "OFF" position.
b. Turn the LP gas tank valve to the "OFF" position.
c. Unscrew the regulator coupling from the LP gas tank valve by turning the quick coupling nut
counterclockwise.
d. Place the LP gas tank valve dust cap provided with the tank back on securely.
Cleaning & Maintenance
Proper maintenance is required to reduce potential flare-ups and extend the life of your grill. Team Grill also highly
recommends using a grill cover to further protect your grill.
Team Grill Patio Series User Guide
IMPORTANT: Do not use oven cleaner or other abrasive cleansers. Do not use mineral
spirits or cleaners that contain citrus products.
IMPORTANT: Do not use a wire brush on the stainless steel or porcelain-enamel surfaces
of this grill, as this will cause scratches.
IMPORTANT: When cleaning stainless steel surfaces, rub in the direction of the grain to
preserve the look of your stainless steel.
IMPORTANT: DO NOT USE ACID DETERGENT AND/OR ANTIRUST AGENTS TO CLEAN
THE CONTROL PANEL. SUCH STRONG CLEANSERS MAY REMOVE THE PRINTED
INSTRUCTIONS.
position to light the
/ HIGH"
Page 37