Table of Contents
Advertisement
burner. DO NOT OPERATE THE SIDE BURNER WITH THE SIDE BURNER COVER IN THE CLOSED POSITION.
To close: Reverse the opening procedure. IMPORTANT: When grill is not in use, keep the side shelves closed in
order to preserve the look of your grill.
Hanging the Warming Rack (MVP Model Only)
The warming rack in the Team Grill Patio Series MVP can be removed to create additional clearance for larger
foods such as whole turkeys or "beer can chicken." To remove the rack, simply lift the front of the rack out of its
holders and then slide it forward until the back bars are clear from the back of the grill. When not being used,
the warming rack can be hung from the two clips mounted on the top of the firebox, located just above the
warming rack. To re-insert the warming rack, insert the back bars into the holes in the rear of the firebox and
lower the front of the rack into its holders.
Special Instructions for Liquid Propane (LP) Models
IMPORTANT: Team Grill liquid propane (LP) models are intended for use with liquid propane (LP) gas only. Do not
use with natural gas. The conversion to or attempted use of natural gas (NG) in LP models is dangerous and will
void your warranty.
Failure to follow the safety information outlined in this User Manual may result in serious bodily injury or
death, or in a fire or an explosion causing damage to property.
LP Gas:
▪ Is explosive under pressure.
▪ Is heavier than air and thus settles in low areas.
▪ Is extremely flammable and hazardous if handled improperly.
▪ Has no natural odor. An odorant has been added to notify you of any potential leaks.
▪ Can cause freeze burns when in contact with skin.
LP Gas Tank Requirements and Instructions
1. An LP gas cylinder is required to operate this appliance. The LP gas cylinder is not included with this
appliance.
2. Be sure to use only one (1) 20lb (9.1kg) LP gas cylinder with a Type 1 valve with this appliance as
required by the American National Standards Institute (ANSI) and the Canadian Standards Steering
Committee.
3. The LP gas tank must:
a. Be marked "Propane."
b. Be constructed and marked in accordance with the Specifications for LP Gas Cylinders of the U.S.
Department of Transportation (D.O.T.) or the National Standards of Canada, CAN/CSA-B339,
Cylinders, Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as
applicable.
c. Not have a capacity larger than 20 lbs (9.1kg) with approximate dimensions of 18" (45.7cm) high
and 12" (30.4cm) diameter.
Team Grill Patio Series User Guide
Page 30
Hide quick links:
Advertisement
Table of Contents
