Hose And Regulator Maintenance; Attaching The Lp Gas Tank - Team Grill PMV06091 User Manual

2. If the burner valves are open prior to the LP gas cylinder service valve being opened, the connection will
interpret this free flow of gas to be a leak.
3. The connections safety feature will reduce gas flow from the regulator to the appliance to a minimal
level.
4. Be sure that all burner valves are closed prior to opening the LP gas cylinder service valve to ensure that
the connection flow limiting device is not triggered mistakenly.
5. If the connection flow limiting device is triggered mistakenly, close the LP gas cylinder service valve and
the burner valves, wait 10 seconds to allow the device to reset, open the cylinder service valve, then
open the burner valves and light the grill as per lighting instructions.

Hose and Regulator Maintenance

1. Inspect the hose before each use of the appliance. If the hose shows signs of cracks, abrasions, cuts or
damage of any kind, do not operate the appliance. Replace the hose before using the appliance. For
assistance with replacing the hose, call our customer service line at 888-978-4675.
2. Inspect the seal inside the CGA No 791 service valve on the LP gas cylinder when replacing the cylinder
or at least once per year. If there is any indication of damage, have the seal replaced by a certified gas
dealer before operating the appliance.
3. Do not use tools to tighten the CGA No 791 connection nut onto the LP gas cylinder service valve – hand
tighten only.
4. Be sure not to cross thread the connection when tightening the CGA No 791 connection on to the LP gas
cylinder service valve.
5. Always perform the "leak test" (See "Checking for Leaks" section of this manual) after attaching the
connection to the LP gas cylinder service valve.
6. The regulator shall be installed in such a location that it will not reach a temperature above 130
o
(54.4 C).

Attaching the LP Gas Tank

1. Only connect the LP gas tank to this grill while outdoors.
2. Turn the LP gas tank valve clockwise to the "OFF" position.
3. Make sure all burner control knobs are in their "OFF" position.
4. Place the LP gas tank into the tank hole on bottom shelf (PRO model) or tank trolley (MVP model), so
that the LP gas tank valve faces the front right corner of cabinet.
5. Remove the plastic dust cover from the LP gas tank valve (save for future use).
6. Thread the regulator coupling through the hole in the right side of the grill cabinet. Screw the regulator
coupling onto the LP gas tank valve, clockwise, or to the right. Hand-tighten only. NOTE: This connection
tightens clockwise and will not allow gas to flow unless the connection is tight.
Team Grill Patio Series User Guide
IMPORTANT: Be sure to protect the hose from dripping grease and any hot surfaces –
including the base of the appliance. Serious danger may result if the hose contacts any
hot surface.
WARNING: Do not use a wrench to tighten the connection. Using a wrench could
damage the regulator coupling and could cause a leak.
o
F
Page 33