Step 9, Install Framed Panels - GE Monogram ZIS360N Installation Instructions Manual

Installation Instructions
[ STEP INSTALL FRAMED PANELS GotoStep
9A
for Overlay
Panels
b.
p ---
P - 4m
k
Install door panels:
• Open door to 90 °. Remove the 6 Phillips head screws
from the door handle.
• Remove handle. Retain a11 screws.
• Remove 6 screws holding trim, lift off trim. Retain
SCFOWS.
• Slide framed panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of the
freezer door. To avoid damage to the dispenser, the
trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel and
slide into the hinge side trim.
• Reinstall the top trim piece with screws.
* There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the FRONT screw holes.
* Secure the handle to the door using the REAR screw
holes.
* Follow the same procedures to install the opposite
panel.
* Check to be sure handles are evenly aligned with each
other at the top. To adjust, loosen handle screws and
slide up or down. Tighten screws.
i
Handle
[rim
Supplied
Handle Shown
in 114"Panel
Position
/Door_im
Refrigerator
Door
¢1 . •
to SecureTrim
UseRearHoles
to SecureHandle
Custom handles
If you are using custom handles, the handle
must be
properly secured to the panel before sliding the panel
into the trim.
* The cabinet manufacturer will supply the custom
handle and hardware.
* Secure the door trims using both the FRONT and
REAR screw holes. Discard supplied handles.
15