Step 10, Install Dispenser Trim - GE Monogram ZIS360N Installation Instructions Manual

Installation Instructions
ISTEP 101 INSTALL DISPENSER
TRIM
Skip this step is you are installing a stainless
steel wrapped or a non-dispenser refrigerator.
There are two dispenser trims shipped with your
refrigerator. Select the appropriate trim for your
application.
J
Framed
Panel
Trim
Overlay
Panel
Td m
Compare the dispenser trims. Note that the inside
depth of the frames are different. Choose the trim
with less depth For framed panels, choose the
deeper one Foroverlay panels.
Dispenser trim fit over the custom panel depends on
correct panel thickness. See pages 7 and 8 for panel
construction information.
I -
, Press and snap the dispenser
trim into the dispenser
recess on the refrigerator door.
If an excessive gap exists around the dispenser trim or
if the panel fits loosely in the door frame, foam tape
may be applied to help improve the fit. Remove the
trim and panel and apply foam tape to the door
around the dispenser and in the corners.
[STEP 11] CONNECT WATER SUPPLY
Check to be sure that refrigerator power cord is not
plugged into the wall outlet.
Jl
\ Refrigerator House
_.Water Supply Water Supp_
, Locate and bring copper
tubing to the front of the
cabinet.
* Turn the water on to flush debris from line. Run
about a quart of water through tubing into a bucket,
then shut-off water.
* Slip a 1/4" nut and ferrule (provided) over both
ends of the copper tubing. Insert tube into the
union fitting on the unit and tighten nut to union.
* Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with toekick installation.
17