Table of Contents
Advertisement
STEP 10 INSTALL 1/4" FRAMED PANELS
Use Front Holes
to Secure Trim
Use Rear Holes
to Secure Handle
Install door and drawer panels:
• Open door to 90°. Remove the 4 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 4 screws holding trim, lift off trim.
Retain screws.
• Slide framed panel into the door trim.
Installation Instructions
Handle
Trim
Standard supplied handle shown
in 1/4" panel position.
14
Right hand models shown. Use the same instructions
for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 10A.
Door Trim
Refrigerator
Door
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original screws
in the FRONT screw holes.
• Secure the handle to the door using the REAR
screw holes.
• Follow the same procedures to install the drawer panel.
Advertisement
Table of Contents
