Step 4. Household Water Filtration; Step 5 Install Side Panels; Step 6 Install Case Trim - GE Side by Side Refrigerators Installation Instructions Manual

Side by side refrigerators
Hide thumbs Also See for Side by Side Refrigerators:
Table of Contents

Advertisement

STEP 4 INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEM
Skip this step if you do not have a household water
filtration system
If the water supply to the refrigerator is from any
household water filtration system, the filter cartridge
should be removed. For better ice and water
performance, remove the filter and install the filter bypass
plug.
Rotate Counterclockwise To
Remove

STEP 5 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 1/4" side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting the refrigerator in place.

STEP 6 INSTALL CASE TRIM

Install case trim using supplied right hand and left hand
case trim pieces and case trim screws. Attach case trim
to each side of case as shown in illustration using case
trim screws in holes provided down each side of case.
Installation Instructions
Filter Bypass
Plug
17
STEP 7 ANIT-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
AVERTISSEMENT
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une porte
ouverte; ils doivent donc être fixés pour prévenir le
basculement vers l'avant et le risque concomitant
de blessure grave ou fatale. Lisez et suivez
les instructions d'installation complètes pour
l'installation du système anti-basculement.
Flush Installation Only
• Cut a 1/2" x 4" block, 35" long.
• Measure and mark under the soffit, 5-1/4" from the
front edge of the cabinet.
• Secure the wood block to under the soffit. From
the bottom of the block to the finished floor should
measure 84". See the illustration.
Tip Over Hazard.
Risque de

Advertisement

Table of Contents
loading

This manual is also suitable for:

36"42"48"

Table of Contents