Step 12, Install Framed Panels - GE ZISS480NXBSS Installation Instructions Manual

Installation Instructions
[STEP 12] INSTALL 114" FRAMED PANELS
Go to Step 12A for Overlag Panels
p..
Install door panels:
• Open the door to 90 °. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
• Slide the framed panel into the door trim.
Dispenser Models Onlg:
• The dispenser controls protrude begond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel
and slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace the handle side trim bg installing the original
screws in the FRONTscrew holes.
• Secure the handle to the door using the REARscrew
holes.
• Follow the same procedures to install the opposite panel.
• Check to be sure the handles are evenlg aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
NOTE:Aluminum cover trim is supplied for use with
custom handles on overlay panels. It is not intended for
use with 1/4" panels. Discard the cover trim when using
1/4" framed panels.
Handle
Trim
SuppliedHandle
Shownin 1/4"
PanelPosition
Refrigerator
Door
UseFrontHoles
to SecureTrim
UseRearHoles
to SecureHandle
15