Table of Contents
Advertisement
22
Select or clear the Enable audio mapping option. Enable this option to
4
customize the audio mapping settings as explained in step 5, or clear this
option to use your Multi card's default audio mapping settings. By default,
analog audio output pairs 1/2 and 3/4 will automatically output audio tracks
1/2 and 3/4 respectively from the source connected to Multi SDI output 1.
The analog audio outputs are genlocked to the source selected on the
Genlock
If you selected the Enable audio mapping option, customize your Multi
5
card's audio mapping as follows:
$
$
¦ Note
the Enable audio mapping option. See
on page
$
Chapter 4, Configuring Your Multi System
pane (see
"Specifying your genlock settings"
Multi-I/O
Select the Source of the audio, and then the Audio tracks
that you want to monitor for each audio output pair. The specified tracks
will be routed to the corresponding Multi analog audio output connectors
for monitoring.
Multi-Playback
For each of the Multi analog audio output pairs, select
the Source of the audio and the Audio tracks that you want to monitor.
The specified tracks will be routed to the corresponding Multi analog
audio output connectors for monitoring.
The currently selected genlock frame rate is displayed to the right of
19
to modify your genlock settings.
You can mute a Multi analog audio output pair by selecting Mute for the
corresponding audio pair.
on page 19).
"Specifying your genlock settings"
Advertisement
Table of Contents
