Installing The Software - Intergraph Intense 3D Pro 3410 Installation Manual

4

Installing the Software

If you received your Intense 3D Pro Graphics pre-installed from Dell, the
graphics drivers for Microsoft Windows NT are pre-installed by Dell. The
following section only applies if you have purchased your Intense 3D Pro
Graphics as a customer kit, or upgrade.
Install the Intense 3D Video Display Driver
Refer to the Microsoft Windows NT documentation and online Help for more
information on installing drivers and software application programs, and
configuring your computer's video display.
To install the Intense 3D video display driver:
1. Insert the first diskette containing the Intense 3D video display
driver into the computer's floppy disk drive.
CAUTION Make sure you have the correct driver to use with the Windows
NT 4.0 operating system. If you are unsure, refer to the
. file on the driver diskette for this information.
README TXT
2. From the operating system Start menu, go to Settings/Control Panel
and click on the Control Panel icons.
3. Click the Display icon in Control Panel. The Display Properties
menu appears.
4. Click the Settings tab.
5. Click the Display Type button and bring up the Display Type panel.
6. Click the Change button and bring up the Change Display panel.
7. Click Have Disk and bring up the Install From Disk panel.
8. In the Install From Disk panel, make sure the Copy manufacturer's
files from: is set to A:\ . Click OK.
9. Verify that the Intergraph Intense 3D Pro driver is highlighted in
the Change Display dialog, and click OK.
10. Click Yes when asked if you want to install a third-party driver.
11. The driver files from Disk 1 are copied from the diskette to your
computer's primary hard disk drive. You will be asked to insert
Disk 2 and click OK. The installation will continue copying files.
12. After the driver files are successfully copied, a message that the
driver successfully installed displays. Click OK.
13. Click Close to exit the Display Type dialog.
15