Installing The Hardware; Start The Installation - Intergraph Intense 3D Pro 3410 Installation Manual

3

Installing the Hardware

Refer to your Dell Computer User's Guide documentation for instructions on
opening and closing the computer, identifying the AGP and PCI slots, and
adding expansion cards.

Start the Installation

To start the installation:
1. Turn off power to the computer and to the monitor. Physically
remove the power cord from the system and allow the Flea Power
to dissipate for 15-30 seconds before proceeding.
2. Open the computer to gain access to the AGP and PCI slots.
3. If your computer has an installed graphics adapter, remove it.
4. Remove the slot cover from the selected slot(s). Retain the screw
from the slot covers; you will use them to secure the cards to the
computer's chassis.
Install the Intense 3D Pro Graphics Accelerator
Follow the instructions that pertain to the specific graphics accelerator you
are installing.
To install an Intense 3D Pro 3410T Accelerator:
1. Align the card with the AGP slot, making sure the gold-fingered
connectors on the card's edge are aligned properly with the slot
connector.
2. Push the card into the slot firmly and evenly until it is fully seated in
the slot connector.
3. Visually inspect the connection. If it does not appear to be correct,
remove and reinstall the card.
4. Use the screw you removed previously to secure the card to the
computer's chassis.
To install an Intense 3D Pro 3400T Accelerator:
1. Align the card with the PCI slot, making sure the gold-fingered
connectors on the card's edge are aligned properly with the slot
connector.
9