Steps To Change The Battery - WayFinder z250 Operation Manual

Digital vehicle compass
Table of Contents

Advertisement

HEADER
TIMER MODE
The timer can be paused any number of
times. The timer will continue to run even
though the Wayfinder is in a different mode
or has timed-out. The timer will continue to
run until it is paused or reset.
Battery life of the Wayfinder is dependent
upon usage, but on average the battery life is
500 hours. The battery should be changed
when the display is dim or blank, or when the
backlight flickers. Using the backlight drains
significantly more power than the compass
alone. Therefore, to maximize battery life,
use the backlight only when necessary.
The Wayfinder uses one Lithium coin cell
battery (3 volt), #2032. These can be found
at most major retailers who carry batteries.
Removal requires the use of a small Phillips
screwdriver (PH 1 or #1 Phillips)

Steps to Change the Battery :

1. Place the compass on a solid surface with
the display facing down.
2. Hold the compass firmly, and completely
remove all four screws from the case
rear.
3. Remove the case rear and set aside. This
exposes the printed circuit board (PCB)
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents