Backlight Time-Out - WayFinder z250 Operation Manual

HEADER
BASIC MODE
Steps to select the backlight shut-off :
1. Press the ADV button until the"BASIC"
icon is displayed in the upper right
corner.
2. Press and hold the ADV button and
"CAL" flashes.
3. Press the ADV button two more times
(In this case "L" stands for light and 10 is
ten seconds.)
4. Press the ENT button. The numbers next
to the "L" should flash.
5. Press the ADV button to step through
the shut-off selections: 10, 30, 60, or OFF.
Stop at your desired selection for the

backlight time-out.

6. Press the ENT button once to set your
selected time-out and "L" and the select
time-out value should flash.
7. Press ADV
programming mode. The display should
now be in Basic mode.
If at any time during programming no
button is pressed for 30 seconds, the unit
exits out of programming mode.
The unit must be in Timer to use any of
the features described in this section.
14
twice to exit from