Brake Light/Turn Signal; Glove Box; Cup Holder; Steering Wheel - Cushman HAULER 800X Owner's Manual

INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

11. Brake Light/Turn Signal

The combination brake light/turn signal assemblies are located on the rear fenders.
3

12. Glove Box

A passenger-side locking glove box is standard, driver-side is offered as an option. A separate key is used for the
locking glove boxes.

13. Cup Holder

A cup holder is provided for convenience of both the driver and passenger.

14. Steering Wheel

The steering wheel located in front of the driver seat is used to steer the vehicle. The steering wheel is also installed
with scorecard holder assembly.

15. Choke

The choke is used to aid cold starting . See COLD STARTING section for operating instructions.

16. Tail Gate Operation

To open the tail gate, lift tail gate straight up with a sharp upward pull to lift out of the closed position and pivot out for
open position. To remove the tail gate, remove the side cables from the loadbed and open tail gate until it is straight
down, move tail gate panel straight up to remove from pins and remove from the load bed. Reassemble in reverse
order.
3 - 6