Capacities And Replacement Parts - Cushman HAULER 800X Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

CAPACITIES AND REPLACEMENT PARTS

Fuel Tank / Fuel
Engine Oil
Oil Filter
Air Filter
Spark Plug
Starter/Generator Belt
Clutch Belt
Rear Axle Oil
Fuse
LED Bulb
Headlight Bulb
Turn Signal Bulb
Tail Light Bulb
Capacities and Replacement Parts
BOLT SIZE 1/4"
Grade 2
Grade 5
Grade 8
BOLT SIZE
Class 5.8
(Grade 2)
5.8
Class 8.8
8.8
(Grade 5)
Class 10.9
10.9
(Grade 8)
Ref Tsp 1
6.0 gal (22.5 liters) / 87 Octane Min.
1.4 US qt (1.3 liters)
P/N 26591-G01
P/N 28463-G01
NGK BPR2ES (P/N 25523-G3)
.020 - .030" (.71 - .75 mm) Gap
P/N 606138
P/N 606136
51 oz (1.5 liters) / SAE 30
15 amp (P/N 18392-G1)
(P/N 619101)
(P/N 619100)
(P/N 619102)
#1157 (P/N 21759-G1)
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
5/16" 3/8"
4 8 15
(5) (11) (20)
6 13 23
(8) (18) (31)
6 18 35
(8) (24) (47)
M4 M5 M6
1 2 4
(2) (3) (6)
2 4 7
(3) (6) (10)
3 6 10
(4) (8) (14)
Torque Specifications and Bolt Grades
MAINTENANCE
Hardware
Periodically, the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
with the Torque Specifications table.
Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, three grades of hardware are used in the
vehicle. Grade 5 hardware can be identified by the
three marks on the hexagonal head and grade 8
hardware is identified by 6 marks on the head.
Unmarked hardware is Grade 2.
7/16" 1/2" 9/16"
24 35 55
(33) (47) (75)
35 55 80
(47) (75) (108)
55 80 110
(75) (108) (149)
M8 M10 M12
10 20 35
(14) (27) (47)
18 35 61
(24) (47) (83)
25 49 86
(34) (66) (117)
5/8" 3/4" 7/8"
75 130 125
(102) (176) (169)
110 200 320
(149) (271) (434)
170 280 460
(230) (380) (624)
M14
55
(76.4)
97
(131)
136
(184)
5
1"
190
(258)
480
(651)
680
(922)
5 - 25