Table of Contents
Advertisement
INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
18. Grab Handles - Front Passenger
The vehicle is equipped with grab handles.
19. Seat Belts - Front
Two seat belts are located for the front seat occupants (driver and passenger).
3
Windshield Wiper (optional)
A two-speed windshield wiper is available as an option.
20. Head Lamps
The vehicle is equipped with two single element head lamps.
21. Front Turn Signals
Vehicle is equipped with front and rear turn signals.
22. Brake Light/Turn Signal
The combination brake light/turn signal assemblies are located on the rear fenders.
23. Brake Light (Overhead)
The vehicle is equipped with an overhead brake light.
24. Battery Compartment
The battery compartment can be accessed by raising the front seat to perform battery maintenance and access the
Run/Tow switch.
25. On-board Charger Receptacle
The charging cord is to be connected to this receptacle while the vehicle is being charged.
26. On-board Charger with DC to DC Converter
On-board charger is used to charge battery while vehicle is parked and the DC to DC converter is used to power
accessories.
27. Run/Tow Switch
The Run/Tow switch is used when the vehicle has become stalled or inoperative.
To reduce the possibility of severe injury or death resulting from loss of vehicle control, consider
the grade of the terrain the vehicle is on and set vehicle's park brake accordingly before switch-
ing the Run - Tow/Maintenance switch to the 'Tow/Maintenance' position. When in the 'Tow/
Maintenance' position, the Anti-Roll Back and Walk-Away safety features of the system no lon-
ger function.
Before attempting to tow vehicle, move the Run-Tow/Maintenance switch to the 'Tow/Maintenance' position. Failure
to do so will damage the controller or motor.
Before disconnecting or connecting a battery, or any other wiring, move the Run-Tow/Maintenance switch to the
'Tow/Maintenance' position.
After connecting a battery, or any other wiring, wait a minimum of 30 seconds before moving the Run-Tow/Mainte-
nance switch to the 'Run' position.
3 - 7
Hide quick links:
Advertisement
Chapters
Table of Contents
