Light Bulb Replacement; Fuse Replacement; Vehicle With A Discharged Battery - Cushman HAULER 800X Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do
not touch new bulbs with bare fingers. Use clean, dry
tissue or paper towel to handle the glass portion of the
bulb.
For vehicles with headlights, locate the screws on
backside of cowl that secure headlight. Remove screws,
pull headlight out and disconnect wires. Connect wires
to new headlight, install in cowl and secure with screws
5 previously removed.
To replace the turn signal light bulb, support turn signal housing from backside
of cowl while removing two screws securing lens. Install new bulb and replace
lens.
Rear
Fender
Tail Light
Bulb

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automo-
tive type fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or
the Service Parts Department.

VEHICLE WITH A DISCHARGED BATTERY

To reduce the possibility of severe injury or death from inadvertent motion, do not attempt to
'jump start' a vehicle.
The vehicle is equipped with a starter/generator and does not idle. When starting the engine, the starter/generator
functions as a starter and with the engine running, it functions as a generator.
With the short running times associated with this kind of vehicle, the generator is more than adequate to maintain the
battery charge level. The generator is not designed to charge a discharged battery.
When engine starts, the clutches engage and cause vehicle to move making 'jump starting' both dangerous and
impractical.
5 - 8
To replace the tail and brake light bulb, roll
the rubber bezel from around the edge of the
taillight and remove lens. Install replacement
bulb and replace lens. To replace the tail and
Tail Light
Lens
brake light bulb, remove hardware securing
lens and remove lens. Install replacement
bulb.
Inside
of Cowl
Headlight
Casing
Screw
Headlight
Bulb
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender