Changing The Oil - Cushman HAULER 800X Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Remove the dipstick and wipe off the entire area with a lint free cloth.
5
Insert the dipstick fully into the dipstick hole and remove. Examine the level of the oil on the dipstick.
The engine can be operated safely as long as oil is within the safe operating range as indicated on the dip stick. Do
not operate vehicle if oil level is below the safe area indicated on the dipstick.
Oil should be added to bring the level into the safe operating range. Remember that oil expands as it gets hot, Do
not overfill. Check that the oil cap is firmly in place.
When adding oil between oil changes, do not mix brands and viscosity grades of oil
The oil dipstick/fill cap must be in place before operating the engine. Failure to install the dipstick/fill cap will result in
oil becoming contaminated and/or oil being discharged into the engine compartment.

Changing the Oil

Tool List
Socket, 3/8" drive.................................................................................................................................................... 1
Ratchet, 3/8" drive .................................................................................................................................................. 1
Extension, 3/8" drive, 8".......................................................................................................................................... 1
Oil drain pan ........................................................................................................................................................... 1
Wrench, 3/4" ........................................................................................................................................................... 1
For maximum performance and longevity, the engine oil should be replaced after the first 8 hours of operation. After
the initial oil change, it should be changed every 125 hours of operation or semi-annually, whichever comes first.
5 - 12
Clean Entire Dipstick
Maximum Oil Level
Fill Cold Engine
For Hot Engine
To This Point
Do Not Overfill
Add Oil
Safe
Operating Range
Hot Engine
Check Oil Level On Dipstick
Qty.