Cushman HAULER 800X Owner's Manual page 56

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Clean the area around filter. Using a filter wrench, strap wrench or other suitable wrench, remove the filter (B) from
the engine and allow the oil to drain. The 'O' rings may remain on engine (A) or filter (B)
5
Remove Oil Filter
Inspect the filter. Make sure the 'O' ring is not left on the engine surface.
Inspect Oil Filter
Be careful of hot oil when drained. It may be hot enough to burn you severely
Drain the oil by removing the drain plug found at the rear of the engine base. Remove using a 3/4" wrench. At the
first oil change, small metal chips and lint may be found. This is normal, resulting from the break-in period. Inspect
the filter at every oil change. The presence of large metal chips could indicate possible damage to the engine.
Oil Drain Plug
Wipe the area around the drain plug mount with a lint free cloth and inspect the drain plug (A) for damage; replace if
necessary. Replace the "O"-ring (B) with a new one and tighten to 61 in. lbs. (7.0 Nm) torque. Apply engine oil to the
oil filter seal and install oil filter onto the engine until the seal contacts mounting surface of the engine. Then turn the
filter 2/3 to 3/4 rotations by HAND(S). Pour in the specified type and amount of oil See "Capacity and Replacement
Parts" chart on page 55.
5 - 14