Fig. 15 Headlight And Turn Signal Bulb Replacement; Fuse Replacement; Vehicle With A Discharged Battery; Transporting Vehicle - Cushman COMMANDER 280 Owner's Manual And Service Manual

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
(Ref Fig. 15 on page 11). Remove screws, pull headlight
out and disconnect wires. Connect wires to new he ad-
light, install in cowl and se cure with screws pr eviously
removed.
Turn Signal Lens
Headlight
Bulb
Ref Hdr 2

Fig. 15 Headlight and Turn Signal Bulb Replacement

To replace the turn signal light bulb, support turn signal
housing from backside of cowl while removing two
screws securing lens. Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the t aillight and remove
lens. Install replacement bulb and replace lens.
Ref Tlr 2
Fig. 16 Tail and Brake Light Bulb Replacement

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver
side seat. Pull out old fuse and replace with a new auto-
motive type fuse. Headlights and fuses are available
from a local Distributor, an authorized Branch or the Ser-
vice Parts Department.
OPERATION AND SERVICE INFORMATION
Inside
of Cowl
Turn Signal
Housing
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender
Owner's Manual and Service Guide

VEHICLE WITH A DISCHARGED BATTERY

To reduce the possibility of severe injury or
death from inadvertent motion, do not attempt
to 'jump start' a vehicle.
The vehicle is equipped with a st arter/generator and
does not idle. When starting the engine, the st arter/gen-
erator functions as a starter and with the engine running,
it functions as a generator.
With the short running times associated with this kind of
vehicle, the generator is more than adequate to maintain
the battery charge level. The generator is not designed to
charge a discharged battery.
When engine starts, the clutches engage and cause
vehicle to move making 'jump starting' both dangerous
and impractical.
If the vehicle battery has become discharged, it must be
charged using a 12 volt charger that is rated at 10 amps
or less. Read and understand all instructions provided by
the manufacturer of the charger.

TRANSPORTING VEHICLE

TOWING

This vehicle is not designed to be towed.
It is recommended that the vehicle be moved by placing
the entire vehicle on a trailer, flatbed truck or other suit-
able transport.

NEUTRAL LOCK

To prevent the driven clutch from turning the rear wheels
during service operations, a neutral lock is located on the
direction selector.
To operate:
Turn key switch to 'OFF' and lift seat. Pull out and rot ate
the neutral lock pin handle so that the pointed portion of
the handle is to the side of th e direction selector cam
(Ref Fig. 17 on page 12). Move direction selector
towards the area between 'F' and 'R'. During that motion,
Page 11